Male End
Male End
 |
 RP SMA End Launch Jackmale pin PCB Mount solder post  US $1.05
|
 4 pin Jones Plug connector new male for cable end US $12.00
|
 New 40 8641 1 4 MALE STEREO CABLE END PLUG US $3.95
|
 BNC MALE CABLE END RG58 SOLDER TYPE CONNECTOR 60358 US $1.95
|
 MALE 5 PIN DIN CABLE END MICROPHONE PLUG 70025 US $1.95
|
 SMA male flange connector end wide termina edge mount US $.99
|
 BNC CONNECTOR ONE MALE END 50 OHM LOAD 2 LOT US $6.95
|
 BNC T CONNECTOR ONE MALE END TWO FEMALE ENDS 50 OHM USE US $1.95
|
 1 4 MALE STEREO CABLE END PLUG 70524 US $1.25
|
 1 4 MALE MONO CABLE END PLUG 70525 US $1.25
|
 TNC 3 PIECE MALE CABLE END RG58 CRIMP TYPE CONN 70500 US $1.50
|
 BNC MALE CABLE END RG59 SOLDER TYPE CONNECTOR 60359 US $1.95
|
 SMA 3 PIECE MALE CABLE END RG174 CRIMP TYPE CONN 1068 US $1.95
|
 New ppb10 1 4 MALE MONO CABLE END PLUG US $3.95
|
 MONSTER Research Gold RCA MALE END CONNECTORS US $4.99
|
 20 PIECE LOT OF BNC TEES 2 FEMALE 1 MALE END US $1.99
|
Is there an adapter thats the male end of a computer monitor cable and the other end S-video?
Looking to display my laptop on a new tv. the only video output on the laptop is a regular monitor port. Not sure of the name. VGA or something liek that.
That will NEVER work.
Those VGA-to-Svideo adapters are intended for video cards that have a specially-built VGA port capable of sending out an S-video signal. It will NOT work with just any VGA port.
The VGA port on your laptop is NOT one of those specially-built ones. If you attempt to use that adapter, you will get no image.
If your laptop's VGA port was one of those S-vid-capable ones, that adapter would have been included with your laptop.
If you want to connect a regular VGA port to a low-quality S-video input, you need a signal converter box that has the electronics to translate VGA to S-video. I would strongly recommend against spending money on something like that, because the image you get will be VERY poor-- It is a limitation of S-video, which is a low-definition-only signal.